In this case, the -c copy flag is used to define the output file in this case, the file editedvideo.mp4. Similarly to -ss, if you don’t want to cut part of the end of the video, but only part of the beginning, you don’t need to apply this flag. The option -t is used to specify the end of the new file in this case, the video will end at 00:02:00. The -i flag used to specify the file to be edited in this case, the file is LinuxHint-vim.mp4. For example, for 2 minutes and 3 seconds timing, you should type 00:02:03. As you can see, the timing format must be HH:MM:SS (Hours, Minutes, Seconds). If you only want to cut part of the end of the video, you don’t need to use this flag. This element crops video frames, meaning it can remove parts of the picture on the left, right, top or bottom of the picture and output a smaller picture. The command below uses ffmpeg to cut the video from the second 00:00:05 specified with the flag -ss this is the flag to define a starting point for your new video in case you want to cut part of the beginning. x and y specify the top left corner of the output rectangle. outh is the height of the output rectangle. Where the options are as follows: outw is the width of the output rectangle. I will be working with this Linux Hint video (duration 00:03:280) I just downloaded for this tutorial. Use the crop filter: ffmpeg -i in.mp4 -filter:v 'cropoutw:outh:x:y' out.mp4. You only need to define starting or end time, or both them if needed and the output file. Yum install ffmpeg ffmpeg-devel How to cut videos using ffmpeg:Ĭutting videos with ffmpeg is a pretty simple, fast, and low resource-consuming task using ffmpeg.
0 Comments
Leave a Reply. |